Bitter pit and cork spot are common disorders of Wisconsin apples. These two disorders don’t occur every year, but when weather conditions are just right (or just wrong, depending on your perspective) they can be major problems. This fact sheet describes the causes of the disorders and what can be done to reduce the severity of the problems.
The name bitter pit will be used for both cork spot and bitter pit since they are related disorders. Bitter pit shows as brownish spots in the fruit flesh. The spots actually occur in the outer layers of the fruit but are visible through the skin. Bitter pit may develop before or after harvest. Cork spot develops before harvest. The flesh layers underlying the skin collapse, become brown and take on a “corky” appearance. The exact underlying cause of these disorders is not known, however, they are both known to be calcium related. Two or three factors are associated with development of bitter pit.
- High tree vigor. Trees that are invigorated by heavy pruning, light crops, or nitrogen applications beyond sufficient ranges have a higher incidence of bitter pit. Pruning is vegetatively invigorating and trees that are heavily pruned will also have light crops and substantial vegetative growth. High nitrogen fertilizer doses also lead to substantial vegetative growth. Vegetative growth competes with fruit for available calcium. If calcium is shunted to vegetative growth it is not available for fruit growth. Further, since calcium moves with water in the transpiration stream, greater leaf area will shunt more water (and calcium) to the leaves rather than fruit.
- Moisture stress. Trees that have received either too much or too little water are more prone to bitter pit. The typical situation is too little water. Related to moisture stress is high temperature. Hot days lead to greater evapotranspiration from leaves. Calcium moves in the xylem along with the water that “feeds” the transpiration needs and ends up in leaves rather than fruit. Once in the leaves, calcium is immobile and will not move back to fruit.
- Large fruit. Large fruit are more generally more susceptible to bitter pit than smaller fruit. A light crop will not only lead to vegetative vigor, but also to larger fruit and these fruit are more likely to show bitter pit.
Three things can be done to reduce the incidence of bitter pit in apples.
- Provide irrigation. I realize that most years irrigation is not critical in Wisconsin and that the cost can be high. During dry spells or drought years, however, it would be very valuable in maintaining soil moisture levels and reducing tree stress.
- Apply calcium sprays. Since calcium is immobile in plants once it has reached its destination, it is good practice to apply calcium to the tree so that some will land on the fruit and be absorbed through the cuticle. Both calcium nitrate and calcium chloride are acceptable, but calcium chloride is far cheaper. Besides, the calcium nitrate just aggravates the “too much vigor” problem. I recommend four pounds of calcium chloride per acre beginning with the first cover spray until late July. Then increase the calcium chloride rate to 6 lbs. per acre. For small orchards this is equivalent to about 6 oz. of calcium chloride per gallon. During prolonged dry weather, eliminate calcium chloride applications to prevent buildup on the foliage and fruit that may cause burning. Don’t make a second application unless it has rained since the previous application. There are different calcium chloride products. Research in several states has shown that all products are equally effective if applied at the same rate of calcium. (Go for the cheap one.)
- Include calcium in postharvest dip tanks or wash water. Michigan research has shown a 4% dip or drench of calcium chloride will reduce or delay the incidence of bitter pit in storage. Mix the solution as 33 pounds of calcium chloride per 100 gallons of water. After storage the fruit must again be washed to remove the calcium deposits on the fruit.
Remember that calcium chloride is corrosive to metal so be sure to clean all equipment thoroughly after using calcium chloride. Painting and upkeep becomes even more important if calcium chloride is used. I wish there were some “magic bullet” that would reduce the incidence and severity of bitter pit. Unfortunately, it is weather related and has several variables that determine its severity and incidence. So, in general, the techniques are keeping vigor under control and maintaining a reasonable crop load to keep competing calcium sinks from accumulating calcium that should go to fruit and then applying calcium in cover sprays and at post harvest will help reduce the problem. There are no easy solutions.
For more information on bitter pit and cork spot: Contact your county Extension agent.
© 2019 the Board of Regents of the University of Wisconsin System doing business as University of Wisconsin-Madison Division of Extension.
An EEO/Affirmative Action employer, University of Wisconsin-Madison Division of Extension provides equal opportunities in employment and programming, including Title IX and ADA requirements. This document can be provided in an alternative format by calling Brian Hudelson at (608) 262-2863 (711 for Wisconsin Relay).
References to pesticide products in this publication are for your convenience and are not an endorsement or criticism of one product over similar products. You are responsible for using pesticides according to the manufacturer’s current label directions. Follow directions exactly to protect the environment and people from pesticide exposure. Failure to do so violates the law.
A complete inventory of University of Wisconsin Garden/Farm Facts/Pest Alerts is available at the University of Wisconsin-Madison Division of Extension Plant Disease Diagnostics Clinic website: https://pddc.wisc.edu.